cutoff frequency造句
1 In this paper, a new signal processing technique, cutoff frequency technique, is developed on the base of SSP.
2 The line array FPA has much higher space cutoff frequency and wider FOV relative to the staring system.
3 Cutoff frequency, such constraint conditions, are set with device's current allowance and voltage stress considered.
4 Methods Design filtered speech software,[www.] 20 students(40 ears)with nomal hearing were studied with low-pass filtered frequency bands(cutoff frequency 0.
5 Using the serial port to send data to realize programmable gain settings and using the GPIO port to set the low-pass filter's cutoff frequency.
6 There is no spectral overlap or mixing as non compressed sounds below the cutoff frequency are not affected.
7 The width of the rectangular cavity was found to affect the cutoff frequency of the device most significantly, while the length of the cavity has least influence.
8 Increasing the effective inductance makes it easy to control the cutoff frequency characteristics of the DGS planar circuits.
9 The causes are analyzed. A new control approach is presented with a "local strain compensation" and a low cutoff frequency inertial link feedback in place of the differential one.
10 Its parameters can be regulated by keyboard in order to control amplification and cutoff frequency step.
11 The sensor programmable variables include channel sample rate, gain, offset, and filter cutoff frequency characteristics.
12 Accordingly, with these factors taken into account and optimized, we developed a wide frequency bandwidth current transducer with a lower cutoff frequency 12kHz and upper cutoff frequency 28MHz.
13 Because the HF horn had a very large mouth diameter it had an inherently low cutoff frequency.
14 A new deep trench termination structure is proposed, which can simultaneously improve cutoff frequency and output power of silicon bipolar transistors.
15 And there is only one even mode having zero cutoff frequency, i. e. , there is a single mode area.
16 Two kinds of dispersion equations are given and the relation between the cutoff frequency and core chiral admittance is studied.
17 Surface breaking cracks have a low-pass effect for the surface wave, and high frequency surface wave cutoff frequency is inverse proportional to the ...
18 Absorption does not vary with the thickness of the structure of low-frequency cutoff frequency, can guarantee to achieve the thickness of 25 cm low-frequency cut-off frequency 40Hz.
19 The calculated results also indicate that higher saturation current, transconductance, and cutoff frequency can be achieved by lowering the parasitic resistances.
20 The insertion of the dielectrics, on the other hand, lowers the cutoff frequency.
21 This result is an alternative expression of the well-known tradeoff between efficiency, cutoff frequency, and enclosure volume.
22 The effects of cage in mine tunnel on the cutoff frequency is analyzed by the finite-element method when the tunnel is regarded as a waveguide, and the numerical results are obtained.