快好知 kuaihz


spanner造句
1. Take your spanner, and tighten the nut. 2. An adjustable spanner should do the job. 3. You'll need a spanner to loosen that bolt. 4. I needed a special spanner and I couldn't beg [/spanner.html], steal or borrow one anywhere. 5. He worked in a garage?hence his nickname "Spanner". 6. I'll need a spanner to change the back wheel. 7. He cursed under his breath as the spanner slipped. 8. A bad result is sure to throw a spanner in the works. 9. Will this spanner do you? 10. But there is a spanner in the works. 11. Bosun's Sail ties, pliers, adjustable spanner, screwdriver, shock cords. 12. He took a spanner from his tool box and tightened up the bolts on the gate. 13. They threatened him with a spanner and screwdriver, then forced him into the back of his Sierra. 14. He changed the spanner for one clearly the wrong size and tried vainly to tighten the nut again. 15. He changed the spanner for one the correct size and tightened the nut. 16. The better choice here is a crescent-pattern spanner which has angled jaws so that it can be reversed in tight corners. 17. Try smearing the spanner jaws with light oil, then dipping them in fine sand. 18. Or even, as Morley evasively said,: A spanner in the works. 19. The spanner in these works is the fact that government is not a profit-making enterprise. 20. Immersion heater spanner Electric immersion heaters fit into a large screwed boss on the top or side of a hot water cylinder. 21. The funding for the project was withdrawn so that really threw a spanner in the works. 22. She fished in her tool box for the right spanner. 23. We broke open the lock with the help of spanner. 24. Let's get this finished before the boss comes along and throws a spanner in the works. 25. I reached into the door pocket and pulled out the heavy wheel nut spanner. 26. He didn't fancy the idea of being treated with a spanner if falling ill. 27. Poor old Richard, torpedoed three times, and then finished 011, near as a toucher, with an adjustable spanner. 28. Full instructions are included, and all you need to add are an adjustable spanner, cross-point screwdriver and penknife. 29. Don't use jointing compound unless recommended Tighten the compression joints using a spanner at either end. 30. Place a shallow container under each valve connection, and loosen one of the couplings with a spanner.