resistor造句
91. You talking about series gate resistor, not Gate - Source resistor.
92. Resistor are usually divided into three series: fixed resistors, variable resistor and special resistance.
93. Discuss the impact on LED brightness uniformity from bias resistor and brightness in this paper.
94. The effect is the same as that of placing a shunt resistor across the active gage.
95. An external resistor from HBUF to HREF defines the frequency range.
96. Any resistor can be equivalent to another resistor in parallel with a current-controlled current source, or to another resistor in parallel with a voltage-controlled current source.
97. In this paper, math model is studied based on physics theory of PV cell, and the influence of series resistor Rs and parallel resistor Rsh on PV cell characteristic is analyzed.
98. Preparation of thermal sensitive thin film resistor is one of key technologies in uncooled micro bolometer IR FPA fabrication.
99. A resistor - condenser circuit at the input the vertical oscillator.
100. A shunt ammeter can be modeled as a voltmeter with a resistor across the input.
101. Since the leakage current through the zener diodes results in a voltage drop across the resistor, low leakage zener devices are desirable.
102. The PGA consists of the differential amplifier with variable source degeneration resistor and the DC-offset correction circuit.
103. The DC-AC difference of the precision resistor due to Peltier Effect can not be obtained by a pure de measurement or an ac one.
104. A kind of synthesized resistor is proposed to emulate thermal resistors in an interface simulator.
105. The three terminals of the potentiometer are available for use as either a variable resistor or a resistor divider.
106. In this paper, the characteristics of NTC thermal resistor and its application in LCD design is introduced.
107. Instrument can decide resistor of loop of ground connection of connective of this ground connection automatically.
108. Diffused resistor model under ESD stress in linear, saturation, multiplication and snapback, and secondary breakdown regions was analyzed.
109. Three-phase autotransformer with pure resistor load is chosed for the simulation experiments.
110. We introduced three kinds of thick film resistor ( TFR ) conductive model.
111. When the user toggles the switch to Position 1, the pin connects to VDD through resistor R5, and the pin bit is one, regardless of the value of the port bit.
112. For a long time, in the absence of an exact solution, the effective resistance of large complex random resistor lattices has been widely studied by using numerical method.
113. This resistor significantly reduces current - output capability and the output - voltage swing with low - resistance loads.
114. The main hardware is composed of thermal resistor as temperature sensor, 87C51 single chip processor, as main control computer, together with amplifier and A/D transfer.
115. One way of explaining this is that pins configured as INPUT make extremely small demands on the circuit that they are sampling, say equivalent to a series resistor of 100 Megohms in front of the pin.
116. This paper gives out the weighted resistor decoding networks of normal DAC and BCD code DAC, works out the universal formulas of connecting resistors, and simulates the circuit with EWB.
117. This paper provides a thin - film resistor loaded microstrip ring resonator for the sub - structure of equalizer.
118. The resistor can be classed adjustive form, and the adjustive form can move right - and - left.
119. The resistor is first measured with test voltage V 1, giving R 1.
120. They are designed to be connected directly to a supply, usually 9 - 12V, and no series resistor is required.
1234567