EMI造句
1. Thorn EMI owns the rights to music from many top Broadway shows.
2. She landed a contract with record label EMI.
3. The main EMI and EMC approaches were pointed out in designing machine tool numerical control system.
4. To reduce the EMI, reverse reset of the diode are studied, and design way about spike-killers and saturable inductors witch can suppress voltage and current spikes are showed.
5. The EMI power line filter is a primary tool available to the designed of electronic equipment for EMC design.
6. It is desiderate to improve competitiveness of Liaoning EMI under that situation.
7. Draw up unit worldwide EMI & EMS certify & standards introduce and approval.
8. The infrared low-attitude early-warning system, which uses the passive mode to detect the target, can resist the Electro Magnetic Interference (EMI).
9. At last, EMI filter is designed for restraining the conducted interference of inverter.
10. Based on the conducted EMI, modeling approaches of power semiconductor, passive component and PCB are related.
11. The experimental(results) show that the EMI level of the integrated motor system has an obvious attenuation after adding snubber and filter.
12. At last integrated EMI filter is realized and propose several ways to reduce the parasitic parameter.
13. The CBFS series is a 3 terminal EMI Suppressor Filter based on multilayer chip capacitor technology.
14. The performances of the two kinds of EMI PMTs are described here.
15. The electromagnetic interference (EMI) is an important problem in microwave system which is caused by harmonic radiations in most cases.
16. The influence on common mode EMI by a synchronous rectifier is analyzed too.
17. They have recorded several discs for EMI including Mozarts Gran Partita, the Harmoniemusik from Entfuhrung aus dem Serail, and works by Dvorak and Myslivecek.
18. The Paper analyzes the conducting EMI propagation path of converter, and presents the working principle of EMI power filter and the design of EMI power filter.
19. This paper describes four calibrating methods of EMI testing systems as follows: comparison method, standard antenna method, insertion loss method, and standard field method.
20. The propagation path of CM EMI is analyzed, then it is concluded that timing is critical for the cancellation of the CM current.
21. Conductive plastics is an important defensive and functional polymer materials in resisting electromagnetic interference ( EMI ) .
22. However, DCM operation causes high peak current stresses and serious electromagnetic interference ( EMI ) problem.
23. Besides switching at a fixed frequency for Flyback converters, quasi-resonant mode is widely used due to its lower switch-on losses and better EMI performance.
24. It also analysis and design of the drive circuit, the sampling circuit, surge suppression circuits and EMI filter, a MATLAB simulation.
25. The spark resistance influences the spark current duration to a certain extent, but has no influence on the EMI of system.
26. Main Products:AC Socket, Circuit Breaker, DC Jack, Digital Switch, Dip Switch, EMI Filter, Fuse Holder, Hook Switch, Key Switch, Micro Switch, Push Swit...
27. Apart from this step, designers should also connect an EMI filter, such as a ferrite bead , to the output of the amplifier.
28. Adopt complete aluminum alloy structure, the hard positive pole of surface is oxidized and processed precisely; the surface has EMI/ RF anti-abrasion layer.
29. Bruch "Scottish Fantasy", "Violin Concerto" at that time do not know why, to see the tape very little EMI, but EMI's cover design is precisely ...
30. The effects of parasitic parameters on the CM current spectrum are also analyzed. To lessen high frequency CM EMI, suppression of surge voltage across the switches is studied.
123